Filter for the removal of nitrates FD10

Code: AQCSET369 AQCSET370 Choose variant
Not rated
€59,60 €49,26 excl. VAT
In stock In stock Choose variant
Connection
Chosen variant is not available. Reset selected parameters.

Flow filter for the removal of medium to high concentrations of nitrates in water. Designed for the treatment of drinking water with installation under the kitchen sink with a connection to cold water to a separate faucet. Maximum flow is 0.5 l/min.

Detailed information

Product detailed description

Nitrate Filter FD10 consists of a wall mount, an outer tube, a cartridge tube, and a special filling of Purolite A520E for the removal of nitrates from water. Purolite A520E is a macroporous strong anion resin specifically designed for removing nitrates from water for drinking water treatment, even in cases where medium to high concentrations of nitrates are present. The filter operates on the principle of ion exchange, converting nitrate ions to chloride ions.

This simple nitrate removal filter is flow-through, thus requiring no special maintenance. The filling just needs regular regeneration with a salt solution or, if necessary, replaced with a new one.

The filter is designed for installation under the kitchen sink with a connection to cold water. A separate water tap is required. Due to the low flow rate, the filter is not suitable for central water treatment.

The product is certified and intended for contact with drinking water.

Regeneration of the nitrate filter filling for filter FD 10

  1. Close the water supply to the filter, release the pressure from the faucet for treated water, and unscrew and remove the filter tube with the nitrate filling.
  2.  Pour out the water from the tube and let the inner tube drain.
  3. Pour 1 liter of saturated salt solution (100% brine = a maximum of 0.16 kg of salt dissolves in 1 liter of water) into the filter tube or some container, and place the inner tube with the filter filling into the salt solution or filter tube for about 30 - 60 minutes.
  4.  Insert the filter tube back into the filter container, tighten it, open the water supply, and let approximately 2 - 5 liters of water flow out to wash away the salt until the water is no longer salty, after which you can use the treated water again.

Package Contents:

  • wall mount
  • outer filter tube
  • inner tube with filter filling

Technical Specifications:

  • dimensions: filter height without mount 32 cm, height with mount 35.5 cm, filter diameter 11.5 cm, mounting distance 12 cm
  • connection 1” or 3/4” (depending on your choice)
  • maximum flow is 28 l / h = 0.5 l / m (please keep in mind that it is important to use it at this flow rate for 100% efficiency)
  • Max. temperature: 40°C
  • maximum water pressure: 8 bar
  • the capacity of the filter filling at 50mg/l of nitrates is 500l, then regeneration is necessary

It is important to know the diameter of the connection to the water supply for selecting the correct thread diameter of 1" or 3/4".

You can purchase a replacement cartridge FVD 10 or replacement filling FND 10 for the filter.

Be the first who will post an article to this item!

Do not fill out this field:

Security check