UV lamp KING LIGHT 4x39 W 4x UV lamp KING LIGHT 39 W

Product detailed description

UV lamps KING LIGHT are designed to remove bacteria, cysts and viruses from water using UV radiation. This disinfection method finds its application for family homes, cottages, laboratories, restaurants, hospitals, and also in industry.

The UV lamp can be installed both horizontally and vertically.

How the UV lamp works

Water enters the stainless steel tube (UV reactor) and flows around the powerful UV lamp located inside the waterproof quartz tube. Ultraviolet radiation of 253.7 nm kills bacteria and viruses and damages their DNA molecular structures, thus preventing them from reproducing. At the same time, it does not alter the chemical content of the water and does not create by-products. Ultraviolet radiation is completely harmless, eco-friendly, easy, inexpensive, and the most modern method of disinfection.

For the UV lamp to fulfill its purpose, it must be operational for at least 10-15 minutes, during which the necessary light frequency spectrum is created that eliminates viruses and bacteria. When the UV lamp does not shine for more than 4 hours, bacteria begin to form colonies and gradually start to grow further into the pipes. For these reasons, it is necessary for the UV lamp to remain continuously turned on. In cases where the water remains unused for more than 2 days (for example, due to a vacation), we recommend turning off the UV lamp. Before using the water, turn on the UV lamp, wait for 15 minutes, and then let enough water flow so that new water passes through the UV lamp.

Health safety is paramount. Water disinfection is therefore crucial for health - for example, a single colony of Escherichia Coli bacteria is sufficient to cause illness.
Therefore, UV lamps KING LIGHT, thanks to their high disinfection efficiency, guarantee absolute certainty backed by 90 years of experience.

Replacement of UV lamp

The lifespan of a UV lamp under constant operation is one year, after which the replacement of the UV lamp is necessary even if it is still illuminated, because after a year the lamp is already burned out and ineffective (different frequency spectrum).

Never handle the UV lamp with bare hands; always use a dry paper towel, for example. Handling with bare hands significantly reduces the lifespan of the lamp.

For convenient replacement of the UV lamp, a space at least the length of the UV lamp in the direction of its removal is needed. To remove the quartz tube, you need to loosen the nut at the opposite end from where the transformer is connected. It is therefore necessary for it to be easily accessible.

Technical parameters:

• Flow rate - up to 12 m³/hour
• Connection 11/2" F
• Power consumption 4x39 W
• Max operating pressure: 8 bar
• Stainless steel UV lamp housing made of Inox 304
• Highly efficient UV lamps
• Dimensions: length 900 mm, height 170 mm, width 140 mm
• New intelligent power supply/transformer with visual LED red diode and sound signaling for malfunctions and UV lamp replacement (not illuminated)

Individual models of UV lamps vary in maximum flow rate, i.e. the flow rate at which they can still ensure a water irradiation intensity of 40 mJ/cm2, according to Czech legislation.

Requirements for inlet water:

• Iron – max. 0.3 mg/l
• Manganese – max. 0.05 mg/l
• Water hardness – max. 2.5 mmol/l
• Mechanical pre-filtration is required.

You should know

Please note that for the proper functioning of the UV lamp, mechanical pre-filtration of the water is necessary. We usually use mechanical filters from our offer. We recommend the pre-filter PX 50 or PX 80.

For connecting the UV lamp, we recommend using surge protection UV Protect S PO20 before the transformer. This will protect the UV lamp and transformer from surges caused by voltage spikes or thunderstorms.

For the proper functioning of the device, we recommend installation by our authorized service throughout the Czech Republic. The installation price depends on the complexity of the installation and the materials used.